Difference between revisions of "Stairs"
(→Categories) |
|||
| (2 intermediate revisions by one other user not shown) | |||
| Line 23: | Line 23: | ||
| − | + | ==Tools Needed== | |
| − | |||
| − | |||
* Hammer | * Hammer | ||
* Drill and drill bits | * Drill and drill bits | ||
| Line 35: | Line 33: | ||
* 4’ Level | * 4’ Level | ||
* Shims | * Shims | ||
| + | |||
| + | ==Categories== | ||
| + | [[Category:Stub]] | ||
| + | [[Category:Difficult]] | ||
| + | [[Category:Global Technology]] | ||
| + | |||
| + | |||
| + | [[Category:Wood]] [[Category:Up to 5 Persons]] | ||
| + | [[Category:Household]] | ||
| + | |||
| + | [[Category:Application]] | ||
| + | |||
| + | |||
| + | [[Category:Howtopedia requested articles]] [[Category:Howtopedia requested drawings]] [[Category:Howtopedia requested images]] [[Category:Pages listed for deletion]] | ||
Latest revision as of 18:29, 15 April 2010
Installation Guide
Step 1 - Remove If remodeling, remove old balusters and any nails that may exist. Step 2 - Layout
Layout balusters on treads where they are 4” on center, or where it meets your local building code.
Use a level to lay out holes under handrail and mark.
Step 3 - Drill
Drill holes ¾” up into handrail and 2” down into tread with appropriate sized drill bit.
Step 4 - Cut
To measure the baluster length on a normal rake, pull your measurements from the center of the hole on the tread to the highest part of the hole on the handrail and add 5/8”-3/4”. Always cut from the bottom of the baluster using a metal cutting saw.
On balconies, measure the length of the nipple and drill that amount into the handrail.
Step 5 - Epoxy
Add epoxy to both holes, add the shoe or knuckle(s) to the baluster (if applicable) and then place the baluster down into the tread and up into the handrail. You will need to add at least one shim to the bottom of the baluster to keep it from sliding down. At this time, you can apply a dab of epoxy and slide the shoe down. Let stand for 24 hours before applying any pressure.
Tools Needed
* Hammer * Drill and drill bits * Metal cutting saw * Epoxy * Epoxy gun * Pencil * Ruller * 4’ Level * Shims
